How Can We Help?
Polar Gateways
Plan an RS-485 communication link
RS-485 defines an electrical signalling interface; Modbus RTU is a protocol that may use it. This is a general installation overview, not a substitute for the gateway and connected-device manuals.
Use the correct network design
- Use suitable twisted-pair communications cable and the prescribed bus topology, termination and biasing. Follow the actual equipment specifications instead of applying one resistor rule to every arrangement.
- Check terminal polarity in both manuals; A/B lettering is not a reliable cross-vendor polarity guarantee.
- Keep the communications route away from significant electrical interference.
- Match protocol, baud/parity/data/stop settings and assign unique Modbus addresses on each shared bus. The demonstrated Polar serial setup is 9600/8/N/1, not a universal RS-485 standard.
Grounding and isolation
Signal reference, cable shield and protective earth serve different purposes. Use the approved grounding/isolation design; do not indiscriminately bond remote grounds or remove protective earth. Ground-potential differences can require isolation.
Sources and limits
General design principles checked against Texas Instruments’ RS-485 Design Guide. Confirm the installation-specific wiring design with the installer.
Table of Contents